Zanussi ZEL 296 Buklet Instruksi - Halaman 14

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kulkas Zanussi ZEL 296. Zanussi ZEL 296 20 halaman. Zanussi instruction refrigerator zla 99 w

Halaman Cetak

INSTALLATION

Important

IF YOU ARE DISCARDING AN OLD APPLIANCE

THAT HAS A LOCK OR CATCH ON THE DOOR,

YOU MUST ENSURE THAT IT IS MADE

UNUSABLE TO PREVENT YOUNG CHILDREN

BEING TRAPPED INSIDE.

Positioning

This appliance should only be installed at a location

where the ambient temperature corresponds to the

climate classification indicated on the rating plate,

which is located at the left on the inside of the

appliance.

The following table shows which ambient

temperature is correct for each climate classification:

+10°C to + 32°C

+16°C to + 32°C

+18°C to + 38°C

+18°C to + 43°C

It should be located in a dry atmosphere, out of

direct sunlight and away from extreme temperature

e.g. not next to a boiler or radiator, or in a very cold

room e.g. an outhouse, where the temperatures may

fall below 10°C (50°F). If these temperatures are

exceeded i.e. colder or warmer, then the appliance

may not operate correctly.

You should also ensure that air can circulate freely

around the back and the top of the cabinet. There

must also be at least 100 mm (4") distance between

the top of the cabinet and any overhanging kitchen

furniture (A). Ideally, the appliance should not be

positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of

the appliance. Do not obstruct the space

underneath. The back of the cabinet may be placed

close to the wall but must not touch it. DO NOT

install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the

adjustable foot, or feet, at the bottom of the cabinet

using your fingers.

Rear spacers

In the bag with the documentation, there are two

spacers which must be fitted as shown in the figure.

Slacken the screws and insert the spacer under the

screw head, then re-tighten the screws.

Depending upon the position which you choose for

your appliance, you may wish to reverse the way in

which the door opens. To do this, refer to instructions

on "Door reversal".

Please ensure that when the appliance is

installed it is easily accessible for the engineer in

the event of a breakdown.

Important

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

NP007

D200

D594