Zanussi ZFC240CL Buklet Instruksi - Halaman 4

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kulkas Zanussi ZFC240CL. Zanussi ZFC240CL 9 halaman. Refrigerator zfc240cl

Halaman Cetak

INSTALLATION

If this appliance featuring magnetic door seals is to

replace an older appliance having a spring lock on the

door or lid, be sure to make that spring lock unusable

before you discard the old appliance. This will prevent

it from becoming a death-trap for a child.

Location

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

Best performance is obtained with ambient

temperature between +18 C and +43 C (class T);

+18 C and +38 C (class ST); +16 C and +32 C (class

N); +10 C and +32 C (class SN).

The class of your appliance is shown on its rating

plate.

Make sure that there is nothing at the back, at the

top and at the bottom of the appliance to obstruct

air circulation.

For more efﬁcient operation of the appliance the

minimum distance between the top of the appliance

and other overhanging kitchen furniture, if any,

should be at least 100 mm (Fig. 1-A).

The best solution is shown in Fig. 1-B (without

overhanging kitchen furniture).

The appliance sides may also be in contact with the

kitchen furniture, provided that air can circulate

freely round the back and top.

One or more adjustable feet mounted on the base of

the appliance make it possible to set it perfectly

level.

D194

Rear spacers

The plastic bag containing all relevant

documentation also contains two spacers to be ﬁtted

into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure

that the arrow (A) is positioned as shown in Fig. 2.

Then turn them through 45 (arrow (A) vertical)

until they lock into place.

Fig. 1

45°

D060

Power connection

Before plugging the appliance into the mains

socket, check that the voltage and frequency

indicated on the appliance's rating plate are the

same as those provided by your home power supply.

A 6% ﬂuctuation above or below rated voltage is

acceptable.

Make sure the plug and the socket are compatible so

that no adaptors need to be used. If necessary,

replace the socket with a suitable one.

The appliance MUST be connected to an efﬁcient

earth or ground tap.

The supply-lead plug in fact incorporates a special

earth or ground contact for this purpose. If by any

chance the sockets of your domestic wiring system

are not earthed, the appliance must be connected to

a separate earth or ground wire by a qualiﬁed

electrician, in accordance with existing safety

regulations.

The manufacturer declines to accept any liability if

this accident-prevention procedure is not followed.

This appliance complies with the relevant UNI

standards and with E.E.C. Directive No. 87/308 of

02.06.87 relative to radio interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent modiﬁcations;

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modiﬁcations.

Cleaning the appliance's interior

Before using the appliance for the ﬁrst time, wash

all internal parts with lukewarm water and neutral

soap so as to remove the typical «new» smell and

then dry thoroughly.

Do not use detergents or abrasive powders as these

will damage the ﬁnish.

Fig. 2