Zanussi ZI 418 Buklet Instruksi - Halaman 11

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kulkas Zanussi ZI 418. Zanussi ZI 418 12 halaman.

Defrosting

Frost is automatically eliminated from the
evaporator of the refrigerator compartment every
time the motor compressor stops, during normal
use.
The defrost water drains out through a trough into
a special container on the back of the appliance
where it evaporates.
Periodically clean the defrost water drainage hole of the
refrigerator, using the special cleaner already inserted
into the discharge hole.
D037
48
Fig. 17
The freezer compartment, however, will become
progressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
Do not use metal tools to remove the frost – they
can cause serious damage.
During this operation it is not necessary to switch
off the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried
out and it is advisable to carry out this operation
when the appliance is empty.
To carry out complete defrosting of the freezer
compartment (
) proceed as follows:
Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
Pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting.
Leave the door open.
Insert the plastic scraper into the appropriate
seating at the bottom centre, as shown in Figure 18,
place a basin underneath to collect the defrost
water.
D068
When defrosting is completed, dry the interior
thoroughly.
Keep the scraper for future use.
Replace the plug in the socket and, after letting the
appliance run for at least half an hour, replace the
previously removed food into the compartment.
Important: A temperature rise of the frozen food
packs, during defrosting, may shorten their safe
storage life.
Never use sharp metal tools to scrape off frost from
the evaporator as you could damage it.
Fig. 18