Zanussi ZR 100 TF Buklet Instruksi - Halaman 6
Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kulkas Zanussi ZR 100 TF. Zanussi ZR 100 TF 10 halaman.
Halaman Cetak
E
D285
the runners to the kitchen unit door using
3.5x16 mm screws.
8mm
PR34
PR35
of the kitchen unit door, if necessary, use the
clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
14
Fig. 8
Position the
runners (E) at
the top and
bottom of the
inside of the
kitchen unit as
shown in Fig. 8
and mark the
position of the
external holes.
After preparing
the holes, screw
Fig. 9
Open both the
appliance door
and that of the
kitchen unit to
approx. 90 .
Place the little
plates over the
runners. Hold the
doors of the
appliance and the
unit together and
mark the holes.
Fig. 10
Remove the little
plates and make
the holes with a
diam. of 2 mm.
Replace the little
plates over the
runners and
screw in the
screws provided
(3.5x16 mm).
For the alignment
D291
Fig. 11
If the appliance is
fixed to the side of
the kitchen unit,
G
simply slacken the
H
screws in fixing
brackets (G),
move the brackets
as shown in the
figure and re-
tighten the
screws.
Then fit cover (H).