Zanussi ZR 60/LW Petunjuk Penggunaan dan Perawatan - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan dan Perawatan untuk Kulkas Zanussi ZR 60/LW. Zanussi ZR 60/LW 8 halaman. Zanussi refrigerator instruction for use and care
Juga untuk Zanussi ZR 60/LW: Petunjuk Penggunaan Manual (8 halaman), Petunjuk Penggunaan dan Manual Perawatan (8 halaman)
Halaman Cetak
Electrical connection
IMPORTANT: The wires in this mains
lead are coloured in accordance with
the following code:
GREEN AND YELLOW - EARTH
BLUE-NEUTRAL
BROWN-LIVE
If you fit your own plug, the colours of
the wires in the mains lead of your
appliance may not correspond with the
markings identifying the terminals in
your plug, this is what you have to do:
Connect the green and yellow (earth) wire
to the terminal in the plug which is
marked with the letter "E" or the earth
symbol -A~ , or coloured green, or
green and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter "N" or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter
"L" or coloured red.
The plug moulded on to the cord
incorporates a fuse. For replacement use
a 13 Amp BS 1362 fuse. Only ASTA
approved fuses should be used.
The fuse cover/carrier must be replaced in
the event of changing fuse.
The right fuse cover/carrier colour is the
one shown by the coloured insert at the
base of the plug or is the colour of the
inscription at the base of the plug.
The plug must not be used if the fuse
cover/carrier is lost.
A replacement cover/carrier must be
obtained from Zanussi Service Agents
whose addresses are listed on the
attached "Zanussi Service and Spares
Nationwide".
This appliance complies with E.E.C.
directive no. 82/499 of 7.6.82 relative
to radio interference suppression. •
Before using
Remove all securing tapes. Wash inside
the appliance with lukewarm water and a
little bicarbonate of soda (one teaspoonful
to one quart of water).
Do not use soap or detergent as the smell
might linger. Dry thoroughly.
4
Operation
Refrigerator - Starting-up
-Temperature Regulation
Insert the plug into the wall socket.
Open the refrigerator door and turn the
thermostat knob, to be found on the
upper right side of the inner liner,
clockwise beyond the
position (stop)
to start the appliance.
Temperature adjustment is obtained by
turning the thermostat knob to the
required setting. A medium setting is
generally the most suitable.
However, the thermostat knob setting
should be adjusted depending on the inner
temperature of the refrigerator, which in
turn depends on a number of factors,
such as the ambient temperature, the
number of times the door is opened, the
quantity of food stored and the locatiomof
the appliance.
Turn the knob clockwise to higher
numbers to obtain a lower temperature or
anticlockwise if a less cold temperature is
required.
Fresh food refrigeration
To obtain the best performance, do not
store warm food or evaporating liquids in
the refrigerator, do cover or wrap the
food, particularly if it has a strong flavour;
do not cover the shelves with any
protective material, such as paper,
cardboard or plastic, which may obstruct
the air circulation through them.
To help you use your refrigerator correctly,
here are some useful hints:
Raw meat (beef, pork, lamb
&
wild fowl):
wrap in polythene bags and place on top
of the salad crisper.
Meat can only be stored safely in this way
for one or two days at the most.
Cooked food, cold cuts, jelly, etc.: these
should be well covered and can be stored
on anyone of the shelves.