Zanussi ZRD 18 JB Buku Instruksi - Halaman 7

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Kulkas Zanussi ZRD 18 JB. Zanussi ZRD 18 JB 18 halaman. Refrigerator- freezer combination

Halaman Cetak

How to save energy

Avoid putting the appliance in a sunny place and near

anything that gives off heat.

Be sure that the condenser and the compressor are

well ventilated. Do not cover the sections where ven-

tilation is.

Wrap products in tightly closing dishes or cling film to

avoid building up unnecessary frost.

Do not leave the door open longer than necessary

and avoid unnecessary openings.

Put warm foods into the appliance when they are at

room temperature.

Keep the condenser clean.

The appliance and environment

This appliance does not contain gasses which could

damage the ozone layer, in either its refrigerant circuit or

insulation materials. The appliance shall not be discarded

together with the urban refuse and rubbish. Avoid damag-

ing the cooling unit, especially at the rear near the heat

exchanger. Information on your local disposal sites may

be obtained from your municipal authorities.

The materials used on this appliance marked with the

sympol

are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chambers in form

of frost and ice goes with the operation of the appliance.

Thick frost and ice has an insulating effect, so it reduces

cooling efficiency as the temperature increases in the

cooling chambers and they need more energy.

At this type of appliance defrosting the cooling plate of

the refrigerator is automatic without any external interven-

tion. The thermostatic control interrupts the operation of

compressor at regular intervals for more or less time -

during this cooling is interrupted - the temperature of the

cooling plate goes above 0 °C due to interior heating load

of the compartment, so defrosting occurs. When the sur-

face temperature of the cooling plate has reached +3 -

+4 °C the thermostatic control restarts operation of the

system.

Melting water flows through defrost water outlet leaded

through the back into the evaporative tray maintained on

the top of compressor and evaporates due to its warmth.

Check and clean the outlet of melting water

coming

during

- a label inside the appliance warns you for this. If it

is clogged the melting water gathered can cause

earlier failure as it can go to the insulating of the

appliance.

defrosting

regularly

Clean the melting water outlet with the supplied pipe

scraper that can be seen in the figure. The pipe scraper

has to be stored in the outlet.

The most typical case of clogging up in the melting water

outlet when you put food wrapped in some paper into the

appliance and this paper contacts back plate of the refrig-

erator and freezes to it. If you remove the food right at this

moment the paper will tear and it can cause clogging up

in the outlet by getting into it.

So you are asked to be careful - because of the

above - when placing foods wrapped in paper into the

appliance.

In case of increased demand e.g. during heat-

waves, the refrigerator temporarily happens to oper-

ate constantly. During this the automatic defrosting is inef-

fective.