Zanussi ZRX 307 W Buku Instruksi - Halaman 32
Jelajahi secara online atau unduh pdf Buku Instruksi untuk Kulkas Zanussi ZRX 307 W. Zanussi ZRX 307 W 36 halaman.
Halaman Cetak
G G B B
Problem
Possible cause
The appliance does not
The thickness of the frost is greater than 4-5 mm on the
cool sufficiently
cooling plate.
Thermostatic control is set too low.
Too many foods to be cooled were put in.
Very warm foods were put in.
Door is not shut properly.
There is no inside cool air circulation.
The appliance cools too
The thermostatic control is set too high.
hard
The appliance does not
Plug is not connected to the mains socket properly.
cool at all
There is no voltage in the mains socket.
Thermostatic control is in „0" position.
The appliance is noisy
The appliance is not supported properly.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Technical data
Model
Gross capacity (l)
Net capacity (l)
Width (mm)
Height (mm)
Depth (mm)
Energy consumption (kWh/24h)
(kWh/year)
Energy class, according to EU standards
Rated current (A)
Weight (kg)
Installing the appliance
Transportation, unpacking
It is recommended to deliver the appliance in
original packaging, in vertical position considering
the protective warning on packaging.
After each transportation the appliance must not be
switched on for approx. 2 hours.
Unpack the appliance and check if there are damages on
it. Report possible damages immediately to the place you
bought it. In that case retain packaging.
Cleaning
Remove every adhesive tape, which ensure the parts not
to move in the appliance.
Wash the inside of the appliance using lukewarm water
and mild detergent. Use soft cloth.
After cleaning wipe out the inside of the appliance.
32
Downloaded from www.vandenborre.be
Instructions for the Installer
ZRX 307 W
Ice-making comp.: 5
Fresh food comp.: 65
Ice-making comp.: 5
Fresh food comp.: 62
525
520
587
0,38
139
A
0,6
24
Solution
Defrost the appliance.
Set higher position.
Put fewer foods to be cooled.
Put foods max. at room temperature.
Check if the door is shut.
Provide inside cool air circulation.
Set lower position.
Check if the connection is proper.
Check if there is voltage.
Check setting of thermostatic control.
Check if the appliance stands stable.
Placement
The ambient temperature has an effect on the energy
consumption and proper operation of the appliance.
When placing, take into consideration that it is practical
to operate the appliance between ambient temperature
limits according to the climate class that is given in the
chart below and can be found in the data label.
Class of climate
SN
N
ST
If the ambient temperature goes below the lower data the
temperature of the cooling compartment can go beyond
the prescribed temperature.
If the ambient temperature goes beyond the upper data
this means longer operating time of the compressor,
increasing temperature in the cooling compartment or
increasing energy consumption.
When placing the appliance ensure that it stands level.
Do not stand the appliance on a sunny place or close to
a radiator or cooker.
Mount the spacers supplied in the plastic bag of the
accessories. Hold the spacer as shown on the Fig.,
using fine strokes of hammer put it in its place.
Ambient temperature
+10...+32 °C
+16...+32 °C
+18...+38 °C