Zanussi ZTAN24FW0 Panduan Pengguna - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kulkas Zanussi ZTAN24FW0. Zanussi ZTAN24FW0 21 halaman.
Juga untuk Zanussi ZTAN24FW0: Panduan Pengguna (21 halaman)
Halaman Cetak
Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
There is too much condensed
water on the rear wall of the re-
frigerator.
Water flows inside the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
16
Possible cause
The door is not closed correct-
ly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
During the automatic defrost-
ing process, frost melts on the
rear plate.
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrapped.
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The Super Freeze function is
switched on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
Solution
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products better.
Refer to "Operation" chapter.
Set a higher temperature. Re-
fer to "Operation" chapter.
Set a higher temperature. Re-
fer to "Operation" chapter.
This is correct. Dry the water
with a soft cloth.
Open the door only when nec-
essary.
Make sure the door is closed
completely.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off Super Freeze func-
tion manually, or wait until the
function deactivates automati-
cally to set the temperature.
Refer to "Super Freeze func-
tion" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.