Clarke X-Pro CAT199 Petunjuk Pengoperasian & Pemeliharaan - Halaman 9
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Alat Listrik Clarke X-Pro CAT199. Clarke X-Pro CAT199 17 halaman. 1/2" air ratchet wrench
Halaman Cetak
DISCONNECTING THE AIR SUPPLY
1. DO NOT disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session and drain daily as
recommended.
STORAGE
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
Store the tool safely in its box in a dry, secure environment. When storing,
replace the blanking plug on the airline inlet once the airline has been
disconnected.
Avoid storing the air tool where the temperature is below 0
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9
o
C.