Zanussi ZOG10311XK Panduan Pengguna - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven Zanussi ZOG10311XK. Zanussi ZOG10311XK 24 halaman.
Juga untuk Zanussi ZOG10311XK: Panduan Pengguna (25 halaman)

Halaman Cetak

1. Product Description

2. Release the screw (C), which keeps the

burner in position.

3. Carefully move the burner off the injector

support (D).

4. Slowly move it to the left side. Do not apply

force to the wire of the spark plug

connector (F) and to the thermocouple

conductor (E).

5. Release the burner injector (D) with a 7 mm

socket spanner and replace it with a

different one which is necessary for the type

of gas you use.

Refer to "Technical information" chapter.

6. Assemble the burner in a reverse sequence.

Replace the gas type sticker near the gas

supply ramp with the one related to the new gas

type.

The gas oven burner does not need any primary

gas regulation.

Make sure that the gas supply

pressure of the appliance obeys the

recommended values.

www.zanussi.com

If the supply gas pressure is

changeable or different from the

necessary pressure, you must fit an

applicable pressure adjuster on the

gas supply pipe.

Minimum level adjustment of the oven

burner

1. Disconnect the appliance from the

electricity.

2. Turn the knob for the gas control to the

minimum position and remove it.

3. Adjust the adjustment screw (A) with a thin-

bladed screwdriver.

Change of

the type of

gas

From natural gas

to liquid gas

From liquid gas

to natural gas

4. Attach the knob for the gas control.

5. Connect the appliance to the electricity.

WARNING!

Only put the mains plug into the

mains socket when all parts are

back into their initial position. There

is a risk of injury.

6. Light the gas oven burner.

Refer to "Daily use" chapter.

7. Set the knob for the gas control to the

maximum position and let the oven heat for

at least 10 minutes.

8. Turn the knob for the gas control from the

maximum to the minimum position.

Adjustment

of the adjust-

ment screw

Fully tighten the

adjustment

screw in.

Release the ad-

justment screw

approximately

1/3 of a turn.