Zanussi ZOG11311 Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven Zanussi ZOG11311. Zanussi ZOG11311 20 halaman.
Juga untuk Zanussi ZOG11311: Panduan Pengguna (20 halaman)

Halaman Cetak

Warning! The adjustment conditions for

this appliance are located on the label or

rating plate.

Warning! The manufacturer is not

responsible for damages caused by an

installation which does not agree with the

instructions in the manual.

Installation environment:

• This appliance is not connected to a combus-

tion products evacuation device.

• Only install the appliance in a room with suffi-

cient ventilation.

• Keep natural ventilation holes open or install a

cooker hood.

• There must be a 130 cm² minimum opening

in the built-in cabinet.

The use of a gas cooking appliance results in

the production of heat and moisture in the room

in which it is installed. Ensure that the kitchen is

well ventilated: keep natural ventilation holes

open or install a mechanical ventilation device

(mechanical extractor hood). Prolonged inten-

sive use of the appliance may call for additional

ventilation, for example opening a window, or

more effective ventilation, for example increas-

ing the level of mechanical ventilation where

present.

Gas connection

The gas supply ramp is on the rear side of the

control panel.

Warning! Do not use rubber flexible pipes.

Warning! Before the gas connection,

disconnect the mains plug from the

mains socket or deactivate the fuse in the

fuse box. Close the primary valve of the

gas supply.

www.zanussi.com

A) Flexible metallic

pipe

B) Gasket

C) Gas supply ramp

1. Do not fully move the oven into the built-in

cabinet (about 30 cm).

There are two connection modes:

a) Connection with flexible metallic pipe

(maximum 2 m):

• Put the supplied gasket between the

pipe and the gas supply ramp.

• Turn the pipe to the 1/2" gas supply

ramp.

b) Connection with rigid metallic pipe

(soft copper, minimum diameter: 8

mm):

• Use a male / female adapter (not

supplied) to install the nut and the

olive on the gas supply ramp.

• Put the pipe into the gas supply

ramp.

2. Use a 22 mm spanner to tighten the nuts.

Keep the gas supply ramp in correct posi-

tion, do not apply force on the gas supply

circuit.

3. Fully insert the appliance into the built-in

cabinet. See instructions in "Building-in the

appliance".

4. Check with the leak detection fluid if the

connection seal is made properly.

Warning! Do not use a flame to con-

trol for leaks!

A) Rigid metallic pipe

B) Nut

C) Olive

D) Male / female

adapter

E) Gas supply ramp