Zanussi ZOG15311 Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven Zanussi ZOG15311. Zanussi ZOG15311 24 halaman.

Halaman Cetak
WARNING!
Do not squeeze the gas supply
ramp and the pipe when you
move the oven into the built-in
cabinet.
3. Seal the connection correctly. Use a leak
detection to control it.
Adjustment to different types of gas
Let only an authorized person do the
adjustment to different types of gas.
If the appliance is set for natural gas
you can change it to liquid gas, with
the correct injectors.
The gas rate is adjusted to suit.
WARNING!
Before you replace the injectors,
make sure that the gas knobs are in
the Off position. Disconnect the
appliance from the electrical supply.
Let the appliance cool down. There
is a risk of injury.
The appliance is set to default gas.
To change the setting always use
the gasket sealing.
Oven injector replacement
1. Remove the bottom plate of the oven cavity
(A) to get access to the oven burner (B).
B
A
2. Release the screw (C), which keeps the
burner in position.
C
www.zanussi.com
3. Carefully move the burner off the injector
support (D).
D
E
F
4. Slowly move it to the left side. Do not apply
force to the wire of the spark plug
connector (F) and to the thermocouple
conductor (E).
5. Release the burner injector (D) with a 7 mm
socket spanner and replace it with a
different one which is necessary for the type
of gas you use (see table in "Technical
Information" chapter).
Refer to "Technical information" chapter.
6. Assemble the burner in a reverse sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
The gas oven burner does not need any primary
gas regulation.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
If the supply gas pressure is
changeable or different from the
necessary pressure, you must fit an
applicable pressure adjuster on the
gas supply pipe.
Minimum level adjustment of the oven
burner
1. Disconnect the appliance from the
electricity.
2. Turn the knob for the gas control to the
minimum position and remove it.
3. Adjust the adjustment screw (A) with a thin-
bladed screwdriver.
17