Zanussi ZOU30601XK Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven Zanussi ZOU30601XK. Zanussi ZOU30601XK 40 halaman.

Halaman Cetak

Hold the door glass panel by its top edge and

carefully pull it out. Make sure the glass slides

out of the supports completely.

Clean the glass panel with water and soap. Dry

the glass panel carefully.

When the cleaning is completed, install the

glass panel and the oven door. Do the above

steps in the opposite sequence.

The screen-printing zone must face the inner

side of the door. Make sure that after the

installation the surface of the glass panel frame

on the screen-printing zones is not rough when

you touch it.

Make sure that you install the internal glass

panel in the seats correctly.

Replacing the lamp

Put a cloth on the bottom of the interior of the

appliance. It prevents damage to the lamp glass

cover and the cavity.

Troubleshooting

WARNING!

Refer to Safety chapters.

What to do if...

Problem

The cooking zones do not oper-

ate.

The oven does not heat up.

The lamp does not operate.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

The back lamp

1. Turn the lamp glass cover counterclockwise

2. Clean the glass cover.

3. Replace the lamp with a suitable 300 °C

4. Install the glass cover.

Possible cause

Refer to the operating instructions for the built-in cooking surface.

The oven is deactivated.

The fuse is blown.

The lamp is defective.

WARNING!

Danger of electrocution! Disconnect

the fuse before you replace the

lamp.

The lamp and the lamp glass cover

can be hot.

CAUTION!

Always hold the halogen lamp with a

cloth to prevent grease residue from

burning on the lamp.

deactivate the circuit breaker.

to remove it.

heat-resistant lamp.

Activate the oven.

Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

Replace the lamp.

Remedy