Zanussi FA1025E Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Zanussi FA1025E. Zanussi FA1025E 26 halaman. Washing machine fa825e; fa1025e

Halaman Cetak

Use

Control panel

1. Detergent dispenser drawer

Programme option buttons

Depending on the programme, different option

buttons can be combined.

When these buttons are pressed, the corresponding

lights come on. When they are pressed again, the

lights go off.

If an incompatible option with the selected

programme has been chosen, the corresponding

light flashes for about 2 seconds.

The option buttons: PRELAVADO or LEJÍA;

DIARIO; SUPER ACLARADO and ANTIARRUGAS

must be selected after the required programme has

been chosen, by turning the programme selector

(see section 8) and before starting the machine, by

pressing INICIO / PAUSA button.

2. PRELAVADO OR LEJÍA button

By pressing this button you have the possibility of

choosing between the following options:

• PRELAVADO option: Adds a pre-wash phase at

the start of the cycle with water heating to 30° C.

In COTTON and SYNTHETIC cycles, performs a

short spin before passing to the washing phase.This

option cannot be selected for WOOL.

• LEJÍA option: Runs water through the bleach

compartment at the beginning of the first rinse in

COTTON cycles.

Press the button as many times as you need to get

the required option. The corresponding light will

come on.

IF BOTH LIGHTS (PRELAVADO AND LEJÍA) ARE

NOT ILLUMINATED, THE PROGRAMME WILL

RUN WITHOUT EITHER PREWASH OR BLEACH.

3. DIARIO button

By selecting this option the washing cycle duration is

reduced. We recommend its use for slightly soiled

cotton and synthetic fabrics.

4. SUPER ACLARADO button

Can be used with all programmes, except wool.

The machine will add 2 rinses to the selected

programme.

This option is recommended for people who are

allergic to detergents and in areas where the

water is very soft.

5. ANTIARRUGAS button

By selecting this option, the water of the last rinse is

not drained, in order to prevent the fabrics from

wrinkling. The corresponding light will remain lit

during the entire washing cycle. When the

programme has finished, FIN light will also

illuminate.

To drain the water follow these three steps:

A) Turn the programme selector dial to "

B) Select

DRAIN or

C) Press INICIO / PAUSA button.

6. INICIO / PAUSA button

After selecting the required programme, by the

programme selector (see section 8), press this

button to start the machine; the corresponding

light stops flashing and will keep lighting until

the programme finishes.

To interrupt the running programme, depress

INICIO / PAUSA button: the corresponding

light starts to flash.

To restart the programme from the point at

which it was interrupted, press INICIO / PAUSA

button again.

SPIN programme.