Zanussi FCS 825 C Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Zanussi FCS 825 C. Zanussi FCS 825 C 44 halaman. Front-loading washing machine
Juga untuk Zanussi FCS 825 C: Panduan Pengguna (48 halaman)

Halaman Cetak

On position

the programme is reset and the

machine is switched OFF.

At the end of the programme the selector

dial must be turned to position

switch the machine off.

Important! If you turn the programme selector

dial to another programme when the machine is

working, the lights in the programme progress

display will start to flash to indicate a wrong

selection. The machine will not perform the new

selected programme.

Select the spin speed, Rinse Hold or No

spin option (8)

Select the spin speed, Rinse Hold option or No

Spin option by turning the spin speed selector.

For the maximum spin speed allowed by each

programme, refer to the chapter Washing pro-

grammes.

• The position 800 is equivalent to 800 rpm/

min for the synthetic and wool programmes

and 700 rpm/min for the delicate wash pro-

gramme.

• The position 400 is equivalent to 400 rpm/

min for all the wash programmes.

Select the desired option by means of

buttons 2, 3, 4 and 5

Depending on the programme, different func-

tions can be combined. These must be selected

after choosing the desired programme and be-

fore pressing the button 6.The relevant light will

illuminate.

If an incorrect option is selected, the corre-

sponding indicator lamp flashes for about 2

seconds. For the compatibility of the options

with the washing programmes, refer to the

chapter «Washing programmes».

Start the programme by pressing button 6

To start the selected programme, press this

button; the corresponding pilot light stops flash-

ing and remains lit.

On programme progress display the pilot lights

A and E illuminate to indicate that the appliance

starts operating and the door is locked.

Altering an option or a running

programme

It is possible to change any option before the

programme carries it out.

Before you make any change, you must pause

the washing machine by pressing the button 6.

The programme can be changed as long as the

button 6 has not been pressed. Changing a run-

ning programme is possible only by resetting it.

Turn the programme selector dial to

then to the new programme position. Start the

new programme by pressing the button 6 again.

Interrupting a programme

Press the button Start\Pause to interrupt a

programme which is running, the corresponding

light starts to flash. Press the button again to re-

start the programme.

Cancelling a programme

Turn the selector dial to

programme which is running. Now you can se-

lect a new programme.

Opening the door after the programme

has started

First set the machine to pause by pressing the

button 6.

After some minutes, the door can be opened,

when the following conditions are observed:

• The water temperature is below 55°C.

• The water level is below the bottom edge of

the door.

• The machine doesn't spin.

If you cannot open the door but it is absolutely

necessary to open it you have to switch the ma-

chine off by turning the selector dial to

ter few minutes the door can be opened

(Pay attention to the water level and tem-

perature!).

and

position to cancel a

. Af-