Zanussi FE 1025 G Buklet Instruksi - Halaman 14

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Zanussi FE 1025 G. Zanussi FE 1025 G 21 halaman. Washing machine fe 1025 g

Halaman Cetak

7. Start the programme

Depress START/PAUSE button, the corresponding

pilot light stops flashing. The door locked light

illuminates and only the pilot light

8. Altering a programme

You can alter the programme before it starts.

When the programme has started, you can only

reset it by turning the programme selector dial to O

and then you can select the new programme.

Start it by depressing the START/PAUSE button.

9. Interrupting a programme

Depress the START/PAUSE button to interrupt a

programme which is running, the corresponding light

starts to flash. Depress the same button again to

restart the programme.

10. Cancelling a programme

Turn the selector dial to O to cancel a programme

which is running.

Now you can select a new programme.

11. Opening the door after the

programme has started

First set the machine to PAUSE by pressing the

START/PAUSE button.

The door can be opened when the door locked light

has gone out.

If the door does not open (the door locked light

remains alight), this means that the water

temperature is above 55°C, that the water level is

above the bottom edge of the door or that the drum

is turning.

If you cannot open the door but you need to open it

you have to switch the machine off by turning the

programme selector dial to "O". After about 3

minutes the door can be opened (pay attention to

the water level and temperature!).

Select the programme again and depress

START/PAUSE to restart it.

12. At the end of the programme

The machine stops automatically.

If the Rinse Hold

remains lit.

End

light is on to indicate that the water must be emptied

out before opening the door.

To do this turn the programme selector dial to "O"

and then to programme

spin programme is performed at the maximum

speed. In order to avoid any creasing in synthetic,

delicate and wool items, the spin speed can be

reduced by means of the relevant selector.

The door can only be opened after the door

locked light has gone out.

Switch the machine off by turning the programme

selector dial to "O".

Remove the laundry from the drum and carefully

check that the drum is empty so as to avoid any

forgotten items being damaged in a subsequent

wash (e.g. shrinking) or their colour running into a

load of whites.

If you do not intend to carry out another wash, close

the water tap.

Leave the door open to prevent the formation of

mildew and unpleasant smells.

option has been selected, the

pilot light remains lit and the door locked

(drain) or

(spin). The