Zanussi FE 1205 Buklet Instruksi - Halaman 21

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Zanussi FE 1205. Zanussi FE 1205 23 halaman. Front-loading washing machine

Halaman Cetak

132990110•gb

17-11-2003

9:42

Something not working?

Problems which you can resolve yourself.

During machine operation it is possible that one of the following alarm codes appears on the display:

- E10: problem with the water supply

- E20: problem with water draining

- E40: door open

At the same time the buzzer sounds.

Once the problem has been eliminated, press the START/PAUSE button

all checks, the problem persists, contact your local Service Centre.

Problem

• The machine does not start up:

• The machine does not fill:

• The machine fills then empties

immediately:

• The machine does not empty

and/or does not spin:

• There is water on the floor:

• Unsatisfactory washing results:

• The machine vibrates or is

noisy:

Pagina 21

to restart the programme. If after

Possible cause

• The door is not firmly closed. (E40)

• The machine is not plugged in or there is no power

at the socket.

• The main fuse has blown.

• The START/PAUSE button has not been

depressed.

• The DELAY START option has been selected.

• The water tap is closed. (E10)

• The inlet hose is squashed or kinked. (E10)

• The filter in the inlet hose is blocked. (E10)

• The door is not properly closed. (E40)

• The end of the drain hose is too low. Refer to

relevant paragraph in "water drainage" section.

• The drain hose is squashed or kinked. (E20)

• The option

has been selected.

• The drain filter is clogged. (E20)

• Too much detergent or unsuitable detergent

(creates too much foam) has been used.

• Check whether there are any leaks from one of the

inlet hose fittings. It is not always easy to see this

as the water runs down the hose; check to see if it

is damp.

• The drain hose is damaged.

• Too little detergent or unsuitable detergent has

been used.

• Stubborn stains have not been treated prior to

washing.

• The correct temperature was not selected.

• Excessive laundry load.

• The transit bolts and packing have not been

removed.

• The support feet have not been adjusted.

• The laundry is not evenly distributed in the drum.

• Maybe there is very little laundry in the drum.