Zanussi FE 925N Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Zanussi FE 925N. Zanussi FE 925N 21 halaman. Washing machine fe 925n; fe 1024 n

Halaman Cetak

132992210.qxd

4/7/03

10:29 AM

11. How to cancel a programme

during its cycle

To cancel a programme that is being carried out,

first pause the washing machine by pressing the

START/PAUSE button, then press the RESET button

repeatedly, until the phase indicator lights go out.

12. How to open the door during

a programme

You can open the door, after having set the washing

machine to PAUSE, provided the following

conditions exist:

• the washing machine is not in the heating phase

beyond 55°C;

• the level of the water is not high;

• the drum is not turning.

If these requirements are met, when you pause the

washing machine, the DOOR LOCKED light goes

out and the door can be opened.

Should it not be possible to open the door, and

should it be absolutely necessary to do so, switch

the machine off by pressing the ON/OFF button.

After approximately 3 minutes, you can open the

door.

Pay attention to the level and temperature of the

water in the washing machine!

When you close the door and press the ON/OFF

button again, the washing machine will resume the

programme from the point where it had been

interrupted.

Pagina

(Nero/Process Black pellicola)

13. End of programme

At the end of the programme, the washing machine

stops automatically and gives an audible signal.

If you had selected the RINSE HOLD option, the

light of the START/PAUSE button flashes and the

phase indicator light

remains lit to indicate that

the water must be drained.

To drain only, depress SKIP/RESET button once

(the drain light

will illuminate) and then depress

START/PAUSE.

To drain and spin, depress START/PAUSE or select

the spin speed by means of button

depress START/PAUSE.

When the programme has been completed the

audible signal is given.

The DOOR LOCKED light goes out at once.

Press the SKIP/RESET button repeatedly to

erase the programme that has just been carried

out. If you omit to do this, the next time you

switch the washing machine on, you will hear the

audible signal.

Note: when you switch the machine on, if you must

erase the previously performed programme, it is

also sufficient to press the FABRIC button and

select a new programme.

Press the ON/OFF button to switch the machine off.

The relevant light will go out.

Remove the laundry from the washing machine.

Check whether the drum is completely empty, by

rotating it with your hand. The purpose of this is to

prevent any items of laundry from remaining

accidentally in the drum, where they might get

damaged in a subsequent wash (e.g. by shrinking)

or bleed colour into another load of laundry.

We advise you to close the water supply tap and

disconnect the plug from the socket.

Leave the door ajar in order to air the washing

machine.

and then