Zanussi FE1200 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Zanussi FE1200. Zanussi FE1200 25 halaman. Washing machine fe 1200

Halaman Cetak

The inlet hose is provided with a water stop device,

which protects against damage caused by water

leaks in the hose which could develop due to natural

ageing of the hose. This fault is shown by a red

sector in the window "A". Should this occur, turn the

water tap off and refer to your Service Centre to

replace the hose.

Water drainage

The end of the drain hose can be positioned in three

ways:

Hooked over the edge of a sink using the plastic

hose guide supplied with the machine. In this

case, make sure the end cannot come unhooked

when the machine is emptying.

This could be done by tying it to the tap with a piece

of string or attaching it to the wall.

In a sink drain pipe branch. This branch must be

above the trap so that the bend is at least 60 cm

above the ground.

Directly into a drain pipe at a height of not less

than 60 cm and not more than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the drain pipe

must be larger than the outside diameter of the drain

hose.

The drain hose must not be kinked. Run it along the

floor; only the part near the drainage point must be

raised.

Electrical connection

This machine is designed to operate on a 220 V,

single-phase, 60 Hz supply.

Check that your domestic electrical installation can

take the maximum load required (2.2 kW), also

taking into account any other appliances in use.

Connect the machine to an earthed socket.

The manufacturer declines any responsibility

for damage or injury through failure to comply

with the above safety precaution.

Should the appliance power supply cable

need to be replaced, this should be carried

out by our Service Centre.

Important

If the socket in your house is not earthed, you have

to do a separate earth connection using the special

green and yellow ground wire which you can find on

the back of your appliance. This wire has to be

connected to an efficient earth.

If, instead, your domestic wiring system is already

earthed, this wire must not be used and we suggest

you to simply cut it off and to throw it away.

The power supply cable must be easily

accessible after installing the appliance.