Zanussi FJ 1094 G Buklet Instruksi - Halaman 22

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Zanussi FJ 1094 G. Zanussi FJ 1094 G 26 halaman. Front-load washer

Unpacking

Before starting the machine up, the packing must be

removed as follows.

You are advised to keep all the packaging for re-use in

case the machine is to be transported again.

Using a spanner unscrew and remove the rear right bolt.

Lay the machine gently on its back, making sure that the

hoses are not squashed.

Remove the polystyrene block from the bottom of the

machine.

Carefully slide out the right polythene bag (1).

Repeat the operation for the left polythene bag (2).

Remove the polystyrene base.

Set the machine upright and remove the two remaining

bolts from the back.

Pull out the three plastic spacers from the holes into

which the bolts were fitted.

Plug the open holes with the plugs which you can find

at the back of the appliance.

Your new washing machine has been designed to be

permanently plumbed in to your home's water supply

and drainage system. However, if this is not possible, it

may be connected to suitable existing taps with the drain

hose discharging into a sink.

The appliance has two inlet hoses, hot and cold, with

female 3/4" BSP thread connectors. If this connection is

not compatible with the plumbing of the existing

installation, a variety of connectors are available from

good hardware stores and plumbers merchants to suit

most domestic plumbing. Any alteration to your existing

plumbing must be carried out by a competent person, or

qualified plumber.

P0255

P0234

P0256

P0233

P0020