Zanussi FJS 1425 W Buklet Instruksi - Halaman 18

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Zanussi FJS 1425 W. Zanussi FJS 1425 W 29 halaman. Front-load washer

Unscrew and remove the filter.

Clean carefully under a fast running tap.

Warning

When the appliance is in use and depending on the

programme selected there can be hot water in the filter.

Never remove the filter during a wash cycle, always

wait until the appliance has finished the cycle, and is

empty. When replacing the filter, ensure it is securely

retightened so as to stop leaks and young children being

able to remove it.

The water inlet filter

If your water is very hard or contains traces of lime

deposit, the water inlet filter may become clogged.

It is therefore a good idea to clean it from time to time.

Turn off the water tap. Unscrew the water inlet hose.

Clean the filter using a hard bristle brush.

Tighten up the inlet hose.

The dangers of freezing

If the machine is exposed to temperatures below 0°C,

certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Unhook the drain hose from the rear support and

position the end of this hose and that of the inlet

hoses in a bowl. Run the draining programme.

To do this:

Switch the machine on

Select a washing programme

Press the SKIP/RESET button three times

Press START/PAUSE button

Disconnect the appliance.

Screw the inlet hose and reposition the drain hose.

When you intend to start the machine up again, make

sure that the room temperature is above 0°C.

With the use of low temperature washes it is possible to

get a build up of residues inside the drum.

We recommend that a maintenance wash be performed

on a regular basis.

To run a maintenance wash:

The drum should be empty of laundry.

Select the hottest cotton wash programme.

Use a normal measure of detergent, must be a

powder (such as Ariel Futur).