Zanussi FJS 1597 W Buklet Instruksi - Halaman 23

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin cuci Zanussi FJS 1597 W. Zanussi FJS 1597 W 28 halaman. Zanussi instructrion manual front-load washer fjs 1197 w, fjs 1397 w, fjs 1597 w

Halaman Cetak

Water inlet

The inlets on the back of the appliance are colour coded,

blue for cold and red for hot.

Before connecting the hoses be sure to fit the mesh

filters «A» supplied as per diagram.

If only a cold water supply is available, connect the two

hoses to a cold water outlet by means of a «Y»

connection piece.

Installation should comply with local water authority

and building regulations' requirements.

The appliance must be given a separate cold water

supply and not be connected to a mixer tap, a single

outlet water heater or a booster pump. A minimum

water pressure of 0.48 bar is required for safe operation

of the appliance.

If you cannot make the cold water connection direct

from the rising mains, you may be able to operate the

appliance from your cold water storage system.

There should be a minimum distance of 5.02m

(161/2 ft) between the appliance's inlet and the bottom

of the water storage tank.

There will be sufficient pressure for the hot water

supply, providing there is a minimun height of 2.74

metres (9 ft) between the bottom of the cold water

storage tank and the bottom of the hot water cylinder.

Set the hoses correctly by loosening the ring nuts. After

positioning the inlet hoses, be sure to tighten the ring

nuts again to prevent leaks.

Water drainage

This appliance is designed to be permanently plumbed

into your home's water supply and drainage system.

The appliance drain hose should hook into a standpipe,

the hook in the drain hose is formed using the plastic

"U-Piece" supplied.

The standpipe should have an internal diameter of

approximately 38mm (see diagram) thus ensuring there

is an air break between the drain hose and standpipe.

When discharging into a standpipe ensure that the top of

the curve in the hose end is no more than 90cm (35.4'')

and no less than 60cm (23.6'') above floor level. The

upright standpipe should have a minimum length of

30cm (12'') from the bottom of the elbow to the top of

the pipe (see diagram).

Make sure that it is designed in such a way, that the end

of the drain hose cannot be covered with water.

P0003

P1039

38 mm.(1/ ") diameter

standpipe

P1040

P0021

3 pin