Zanussi FLD 1006 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci Zanussi FLD 1006. Zanussi FLD 1006 22 halaman. Washing machine fld 1006; fld 1206

Halaman Cetak

Door reversal

The opening direction of the outer door on this

washing machine can be reversed. To carry out this

operation, proceed as follows:

1) Disengage the end of the opening stop (1)

from the door and turn it through 90° to

remove it from its seat (Fig. A).

2) Using a screwdriver, turn plastic plug (2)

through 90° to remove it from its seat (Fig. A).

3 ) Fit plug (2) in the hole left free by opening stop

(1 ) and turn it through 90° to lock it into place

(Fig. B).

4) Fit opening stop (1) into the hole from which

plug (2) was removed and turn it through 90°,

making sure that the latching tooth is facing

towards the right (Fig. B).

5) Remove the door by unscrewing the screws

securing it to the bottom hinge (3 - Fig. A).

6) Unscrew the two plastic screws (4 - Fig. A)

and fit them on the opposite side (4 - Fig. B).

7) Remove the catch hook (5 - Fig. A) by

inserting a screwdriver into the upper hole and

pushing downwards.

8) Remove plate (6) by inserting a screwdriver

into the bottom hole and pushing upwards

(Fig. A).

9) Refit the catch hook (5) and plate (6) on the

opposite sides.(Fig. B).

10) Remove the door catch (7) and plate (8) as

explained in paragraph 7.

11) Turn the door through 180°.

12) Refit the door catch (7) and plate (8), reversing

their position and pressing firmly to engage

the hook (Fig. B).

13) Fit the door onto the washing machine. Insert

the top pin first, then the bottom pin into the

hinge (3 - Fig. B); finally screw the hinge onto

the washing machine.

14) Check that the door is aligned with the

appliance. To do this, loosen screw (9 - Fig. B)

by a couple of turns and re-tighten when

alignment is correct.

15) Fit the flexible end of the door opening stop

into the location provided in the door (1 - Fig.

B).

Fitting a door panel

The door of this washing machine has mouldings to

allow fitting of a decorative panel (stainless steel

sheet, laminated plastic, wood, etc.) to match with

the existing kitchen units.

The dimensions of the panel must be as follows:

Width

Height

Maximum thickness

To fit the panel, remove the moulding by unscrewing

its fixing screws. Position the panel, then refit the

moulding, making sure that it comes into contact with

and firmly clamps the panel.

588 mm

4 mm