Zanussi DE 6850 Buku Instruksi - Halaman 13
Jelajahi secara online atau unduh pdf Buku Instruksi untuk Mesin pencuci piring Zanussi DE 6850. Zanussi DE 6850 20 halaman. Dishwasher zanussi
Juga untuk Zanussi DE 6850: Buku Instruksi (21 halaman)
Halaman Cetak
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer.
The dishwasher is fitted with a number of alarm systems which can help you to quickly determine the cause of any problems, such
as the dishwasher will not start or stops during operation, all push buttons are inoperative except for the ON-OFF push button or the
indicator light of the programme underway and one or more of the phase indicator lights (washing, drying, end of programme) are
flashing.
Press the ON-OFF push button to switch off the dishwasher and carry out the following suggested corrective actions listed below.
Once the checks have been carried out switch on the dishwasher and start a washing programme, if the fault code reappears,
contact your local Service Force Centre.
Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will
be made, even if the appliance is in guarantee.
Symptom
The machine will not start
The machine does not fill
with water
The dishwasher will not drain
Protection against flooding
is active
General
The machine is noisy
The door is difficult to close
Visible lime deposits or
white film on the dishes
The dishes are not quite dry
The dishes are not clean
(poor wash)
Fault code
"Washing" phase
indicator light
is flashing
"Drying" phase
indicator light
is flashing
"Washing" and "drying"
phase indicator lights
are flashing
One or more phase
indicator lights are
flashing
13
Solution
The door has not been properly closed.
The plug is not properly inserted in the power socket.
There is a power failure.
Ensure the water tap is open.
Ensure the mains water supply has not been cut off.
The inlet hose may be squashed or bent. Reposition the
hose.
The inlet hose may be blocked. Switch off the water supply
and clean the filter.
The drain hose may be squashed or bent. Reposition the
hose.
The sink may be blocked. Clear any blockages.
The drain hose extension is not correct. Follow the
instructions for connecting to the waste.
There is no vent in the end of the drain hose.
Close the water tap and contact the Service Force Centre.
Switch off the dishwasher. Switch it back on and start the
programme.
If the alarm reappears, call the local Service Force Centre.
Dishes are rattling against each other, refer to "Loading your
machine".
The spray arms are knocking against the dishes. Refer to
"Loading your machine".
The dishwasher is not level, or not properly built-in.
Check that there is salt and that the salt cap is tight.
Check that the right level of the water softener is set.
The rinse aid has run out or too little is being used.
The baskets are too full.
The dishes have not been arranged properly.
The spray arms do not rotate
The spray arms are clogged.
The filters are clogged.
The filters are not in the correct position.
Not enough detergent has been used or it is unsuitable.
The detergent is old or has gone hard.
The salt container cap is not properly closed.
The washing programme selected is too gentle.