Zanussi DW 65 TCR Petunjuk Penggunaan dan Perawatan - Halaman 22

Jelajahi secara online atau unduh pdf Petunjuk Penggunaan dan Perawatan untuk Mesin pencuci piring Zanussi DW 65 TCR. Zanussi DW 65 TCR 32 halaman. Dishwasher
Juga untuk Zanussi DW 65 TCR: Petunjuk Penggunaan dan Manual Perawatan (33 halaman), Petunjuk Penggunaan dan Manual Perawatan (32 halaman)

Halaman Cetak

Zanussi DW 65 TCR Petunjuk Penggunaan dan Perawatan

Taking Care of Your Machine

Important

Cleaning the Filters

Make sure that the machine is unplugged

It is essential to clean the filter system

and the water turned off before

regularly. It can easily get clogged with

undertaking any kind of maintenance.

scraps of food which will cause the

Please note, when moving house make

machine to work inefficiently.

sure that the machine is not tilted too

There are three filters (see fig. 19 below),

much during transport.

one large circular fin-mesh filter (A) and

two small cone-shaped ones (B & C).

General Cleanin

Inspect, and if necessary clean, the cone

Inspect the filters and spray arm nozzles

shaped filters (C fits inside B) after each

before reloading the machine and remove

wash cycle. Remove them both by lifting

any food scraps. Wipe round the rubber

the outer one (B) up.

gasket at the bottom of the door to

Then remove the inner one (C) by

remove grease which tends to collect

squeezing the two plastic tongues at the

there.

bottom of the outer filter (B). Remove

any food scraps and clean thoroughly

with a stiff saucepan brush and hot

sudsy water.

The large fine mesh filter (A) is cleaned

automatically during the wash cycle by

two extensions on the bottom spray arm.

These extensions direct two jets of water

down the filter which wash any food

debris into the conical filter where they

are trapped. However the filter should be

removed and thoroughly cleaned every

now and then. To remove the filter (A),

first take off the bottom spray. arm by

releasing the catches (D - fig. 20) and

lifting it up. Release the filter by turning

the base of the spray arm in an anti-

clockwise direction (E - fig. 20) then lift

it out.

Clean it with a stiff saucepan brush and

hot sudsy water. Replace the filters and

the spray arm making sure that all the

parts are securely in position.