Zanussi ZDT311 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Zanussi ZDT311. Zanussi ZDT311 20 halaman. Zanussi dishwasher user manual
Juga untuk Zanussi ZDT311: Panduan Pengguna (32 halaman)

Halaman Cetak

Electronic adjustment

The water softener is set at the factory at level 5.

1. Switch on the appliance.

2. Make sure that the appliance is in setting mode.

3. Press and hold function buttons B and C until the

indicator lights for function buttons A, B and C start

to flash.

Use of dishwasher salt

Caution! Only use dishwashers salt. Types of salt

that are not applicable for dishwashers cause

damage to the water softener.

Fill the salt container with

1 litre of water (only the

first operation).

Set switch to position 1 or

4. Release function buttons B and C.

5. Press function button A.

– The indicator light for function button A continues

to flash.

– The indicator lights for function buttons B and C

go off.

– The end indicator light starts to flash.

– You can hear an audible signal.

The setting function of the water softener is activated.

The end indicator light flashes and an audible signal

operates to show the level of the water softener. The

pause is approximately 3 seconds.

Example: 5 flashes / 5 intermittent audible signals -

pause - 5 flashes / 5 intermittent audible signals -

pause - etc... = level 5

6. Press the function button A one time to increase the

water softener level by one step.

7. Press the on/off button to save the operation.

It is normal that water overflows from the salt con-

tainer when you fill it with salt.

Make sure that there is no grain of salt outer of the

salt compartment. Salt which stays on the tank for

a while drills the tank. It is recommended to start a wash-

ing programme immediately after you fill the salt con-

tainer. This prevents of corrosion because of spilled salt.

When you set electronically the water softener to level 1,

the salt indicator light does not stay on.