Zanussi ZSLN2321 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Zanussi ZSLN2321. Zanussi ZSLN2321 25 halaman.
Halaman Cetak
How to change a setting
Make sure the appliance is in setting mode.
1. Press Previous or Next until the indicator
dedicated to the desired setting flashes.
The light related to
value:
•
For the settings with two values (on and
off), the light is either on (= the setting is
on) or off (= the setting is off).
•
For the settings with multiple values (levels),
the light flashes. The number of flashes
indicates the current setting value (e.g. 5
flashes + pause + 5 flashes... = level 5).
2. Press OK to enter the setting.
•
The indicator related to the setting is on.
BEFORE FIRST USE
1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start the programme 30 min to remove any
residuals from the manufacturing process. Do
not use detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
procedure is complete. The procedure is repeated
periodically.
THE SALT CONTAINER
CAUTION! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in
daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container (only for
the first time).
3. Fill the salt container with 1 kg of salt (until it is
full).
indicates the current setting
•
The other indicators are off.
•
The light related to
setting value.
3. Press Previous or Next to change the value.
4. Press OK to confirm the setting.
•
The new setting is saved.
•
The appliance returns to the setting
selection.
5. Press and hold simultaneously 30 min and
ECO for about 3 seconds to exit setting mode.
The appliance returns to the programme selection.
The saved settings remain valid until you change
them again.
4. Carefully shake the funnel by its handle to get
the last granules inside.
5. Remove the salt around the opening of the salt
container.
6. Turn the cap of the salt container clockwise to
close the salt container.
CAUTION! Water and salt can come
out of the salt container when you fill it.
After you fill the salt container,
immediately start a programme to
prevent corrosion.
indicates the current
11