Zanussi ZT 6810 Buklet Instruksi - Halaman 30
Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin pencuci piring Zanussi ZT 6810. Zanussi ZT 6810 32 halaman. Zanussi instruction booklet dishwasher zt 6810
Halaman CetakThe furniture door
The door on this appliance is designed for the overlay of
a panel having the following dimensions:
Width:
596 mm
Height:
664 - 724 mm max
Thickness:
20 mm max
Weight:
2 - 7.5 kg max
The panel height should be no more than indicated,
otherwise complete opening of the door will no
longer be possible as the panel hits against the
dishwasher plinth.
Mounting the furniture door
onto the door
The height of the panel depends on the height of
adjacent kitchen units (see kitchen plinth adjustment).
The panel must be fitted with a handle, as the
dishwasher handle will be hidden by the panel. Drill the
panel with a Ø 2 x 14 bit according to the dimensions
indicated in the figure.
Screw the two fastening pivots in the holes indicated in
the figure.
Mount the decor panel by inserting the two fastening
pivots into the slotted holes of the door. Lift the decor
panel until perfect alignment with the fascia panel is
obtained.
Once the correct position has been found, open the door
and fasten the decor panel by means of the six 4 x 40
screws provided, using the holes through the inner door.
Securing to the adjacent units
To prevent the dishwasher tilting, it must be secured to
either the worktop or adjacent kitchen cabinet/wall using
the brackets supplied.
Insert the two fixing brackets into the slots provided in
the top front part of the dishwasher as shown in the
figure.
Secure the brackets to the adjacent units with the 3.5 x
16 screws using the upper or the side holes.
The appliance must be secured to the
underside of the underside of the
worktop using the brackets provided.
Failure to do this could cause damage
or injury.
596 max
525
=
II92
II79
II80
II54
30
=
PFI16/2UK