Zanussi ZTM 6825 Buklet Instruksi - Halaman 22

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin pencuci piring Zanussi ZTM 6825. Zanussi ZTM 6825 26 halaman.

Building-in

This dishwasher is designed to be fitted under a

kitchen counter or worksurface.

It is essential that the recess dimensions indicated

in the diagram are followed.

No further openings for venting of the dishwasher

are required, but only to let the water fill and drain

hose and power supply cable pass through.

The recess height may be anywhere between 820

and 880 mm from the floor since the dishwasher

incorporates adjustable feet (max 60 mm).

A distance of 2 mm should be allowed between the

top of the dishwasher and the counter top.

To adjust the height proceed as follows:

1. Loosen or tighten the two front feet.

2. The rear foot is adjusted by turning the screw in

the middle of the front kick plate to the left or

right.

A pad is supplied for the rear foot to make sliding

the appliance in and out of the recess easier.

To fit the pad, press it onto the foot.

If required, the dimensions of this pad can be

reduced by breaking it where marked.

Good levelling is essential for correct closure and

sealing of the door. When the appliance is correctly

levelled, the door will not catch on the levelling

spacers, either side of the cabinet.

If the door does not close correctly, loosen or

tighten the adjustable feet until the machine is

perfectly level.

II64

II52

PFI28GB