Zanussi VCH2004R Petunjuk Penggunaan dan Perawatan - Halaman 9
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan dan Perawatan untuk Kompor Zanussi VCH2004R. Zanussi VCH2004R 20 halaman. Built-in ceramic hob
Juga untuk Zanussi VCH2004R: Petunjuk Penggunaan dan Perawatan (20 halaman), Petunjuk Penggunaan dan Perawatan (20 halaman)
Halaman Cetak
3. If anything has inadvertently
melted onto the surface of the
hob, it must be removed
immediately whilst the hob is
still hot, taking all possible
precautions not to burn
yourself. A glass scraper may
be used, again taking care not
to etch the surface.
4. NEVER mix different cleaning
products as chemical mixtures
may interact aggressively.
5. NEVER
use abrasive scourers,
abrasive or corrosive cleaners,
oven cleaners or sprays, stain
removers, rust removers or
powders.
Cleaning the control panel
The control panel surface should
be cared for and cleaned in the
same way as the hob surface. The
control knobs should be cleaned
with a damp cloth which has been
soaked in warmsoapy water. Do
not allow exessive amounts of
water to accumulate around this
area. For ease and
convenience,
the control knobs pull off and
push back on, make sure they are
in the off position before removing
them so that it 1s easy to refit them
to the correct position after
cleaning.
Do's and dont's
for the user
of this appliance
1. DO read this booklet
thoroughly before using this
appliance.
2. DO NOT attempt to remove
the plug from this appliance in
order to connect to a cooker
box. Electrical connection in
this instance must be carried
out by qualified personnel in
accordance with existing rules
and regulations. Zanussi Ltd
disclaim any liability should
this safety instruction not be
complied with.
3. DO NOT attemt to undertake
maintenance of any kind other
than those jobs for which
instructions are given in this
booklet. Telephone your local
Zanussi Service Centre if you
suspect a fault.
4. DO remember to check the
section at the back of this
booklet (What happens if
something goes wrong) before
requesting an engineer to visit,
this may save you a lot of time
and money).