Zanussi ZDG 323 Buklet Instruksi - Halaman 7

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kompor Zanussi ZDG 323. Zanussi ZDG 323 13 halaman. Hobs zdg313

Halaman Cetak

Adaptation to different types of gas

Replacing the burner injectors

1. Remove the pan supports.

2. Remove the burner's caps and crowns.

3. With a socket spanner 7 unscrew and remove the

injectors (Fig. 6), and replace them with the ones

required for the type of gas in use (see Table 2).

4. Reassemble the parts, following the same procedure

backwards.

5. Replace the rating label (placed near the gas supply

pipe) with the relevant one for the new type of gas

supply. You can find this label in the package of the

injectors supplied with the appliance.

Should the feeding gas pressure be different or variable

compared with the required pressure, an appropriate

pressure adjuster must be fitted on the gas supply pipe,

in compliance with the rules in force.

Adjusting the minimum level

To adjust the minimum level of the burners, proceed as

follows:

1. Light the burner.

2. Turn the knob on the minimum position.

3. Remove the knob.

4. With a thin screwdriver, adjust the by-pass screw

(see Fig. 7). If changing from natural gas to LPG,

completely tighten clockwise the screw, until a small

regular flame is obtained.

5. Finally check the flame does not go out when quickly

turning the knob from the maximum position to the

minimum position.

This procedure can easily be carried out, anyhow the hob

has been positioned or built in the working top.

Table 2 : injectors

BURNER

Ultra-Rapid

NORMAL

REDUCED

POWER

4,0

1,2

FO 0392

Fig. 6

Fig. 7

By-pass screw

Table 1 : BY-pass diameters

Burner

Ultra-Rapid

NATURAL GAS

G20/G25 20/25 mbar

inj. 1/100

inj. 1/100 g/h - G30 g/h - G31

146

0,381

Ø By-pass

in 1/100

of mm.

NORMAL

POWER

LPG

28-30/37 mbar

291

286