Zanussi ZEV6240FBV Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZEV6240FBV. Zanussi ZEV6240FBV 16 halaman.

Halaman Cetak
Problem
comes on.
and a number come on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes on.

Installation

WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Connection cable
• For a single phase or two phase connection
use the following (or higher) mains cable
type: H05BB-F Tmax 90°C.
www.zanussi.com
Possible cause
Automatic Switch Off operates.
There is an error in the hob.
Make sure, you operated the hob correctly. If
not the servicing by a service technician or
dealer will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee are
in the guarantee booklet.
• To replace the damaged mains cable use
Attaching the seal
1. Clean the worktop around the cut out area.
2. Attach the supplied seal stripe to the lower
3. Add some mm when you cut the seal stripe
4. Push the two ends of seal stripe together.
Deactivate the hob and activate it
again.
Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If
again, speak to an Authorised
Service Centre.
the following (or higher) mains cable type:
H05BB-F Tmax 90°C. Speak to your local
Service Centre.
edge of the hob along the outer edge of the
glass ceramic. Do not extend it. Make sure
that the ends of the seal stripe are located
in the middle of one side of the hob.
to the length.
Remedy
comes on
9