Zanussi ZGG35214 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZGG35214. Zanussi ZGG35214 28 halaman.
Juga untuk Zanussi ZGG35214: Panduan Pengguna (16 halaman), Panduan Pengguna (16 halaman), Panduan Pengguna (20 halaman)

Halaman Cetak

• Wash stainless steel parts with water, and

then dry them with a soft cloth.

• The pan supports are not dishwasher

proof. They must be washed by hand.

• The enamel coating occasionally can have

rough edges, so be careful when you wash

the pan supports by hand and dry them. If

necessary, remove stubborn stains with a

paste cleaner.

• Make sure you position the pan supports

correctly after cleaning.

• To make the burners work correctly, make

sure that the arms of the pan supports are in

the centre of the burner.

• Be very careful when you replace the

pan supports to prevent the hob top

from damage.

After cleaning, dry the appliance with a soft

cloth.

Removing the dirt:

1. – Remove immediately: melting plastic,

plastic foil, and food containing sugar.

Troubleshooting

Problem

There is no spark when lighting

the gas

The flame is blow out immediately

after ignition

The gas ring burns unevenly

If there is a fault, first try to find a solution to

the problem yourself. If you cannot find a solu-

tion to the problem yourself, speak your dealer

or the local Service Force Centre.

2. Clean the appliance with a damp cloth

3. At the end rub the appliance dry with

The stainless steel can become tarnished if it

is too much heated. Refer to this you must not

cook with potstones, earthenware pans or cast

iron plates.

Cleaning of the spark plug

This feature is obtained through a ceramic ig-

nition candle with a metal electrode. Keep

these components well clean to prevent diffi-

cult lighting and check that the burner crown

holes are not obstructed.

Periodic maintenance

Periodically speak your local Service Force

Centre to check the conditions of the gas sup-

ply pipe and the pressure adjuster, if fitted.

Possible cause

• There is no electrical supply

• Burner cap and crown are

placed uneven

• Thermocouple is not heated

sufficient

• Burner crown is blocked with

food residues

registered engineer, the visit from the custom-

er service technician or dealer may not take

– Stop the appliance and let it cool

down before you clean: limescale rings,

water rings, fat stains, shiny metallic

discolorations. Use a special cleaner

applicable for surface of hob.

and some detergent.

a clean cloth.

• Make sure that the unit is con-

nected and the electrical sup-

ply is switched on.

• Control the fuse. If the fuse is

released more than one time,

refer to a qualified electrician.

• Make sure that the burner cap

and crown are in correct posi-

tions.

• After lightning the flame, keep

the knob pushed for equal or

less than 10 seconds.

• Make sure that the injector is

not blocked and the burner

crown is clear of food particles.

If you operated the appliance incorrectly,

or the installation was not carried out by a

Remedy