Zanussi ZGG35214 Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZGG35214. Zanussi ZGG35214 16 halaman.
Juga untuk Zanussi ZGG35214: Panduan Pengguna (16 halaman), Panduan Pengguna (28 halaman), Panduan Pengguna (20 halaman)

Halaman Cetak

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

To prevent contact between the cable and the

appliance below the hob use the clamps which

are on the side of the cabinet.

A) Rigid copper pipe or flexible pipe of

stainless steel

Connection cable

To replace the connection cable use only the

special cable or its equivalent. The cable type

is: H05V2V2-F T90.

Make sure that the cable section is applicable

to the voltage and the working temperature. The

yellow / green earth wire must be approximately

2 cm longer than the brown (or black) phase

wire.

Building In

min. 650 mm

If several 30 cm hobs are to be installed side by

side into the same cut out, an assembly kit,

including a support side backer and

supplementary seals is available at our Service

Centres. The relevant installation instructions

are supplied within the kit package.

A) supplied seal

B) supplied brackets

Installing hob under the hood

Possibilities for insertion

The panel installed below the hob must be easy

to remove and let an easy access in case a

technical assistance intervention is necessary.

490 mm

270 mm

CAUTION!

Install the appliance only on a

worktop with flat surface.

If you install the hob under a hood,

please see the installation

instructions of the hood for the

minimum distance between the

appliances.