Zanussi ZGM 782 Buklet Instruksi - Halaman 8
Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kompor Zanussi ZGM 782. Zanussi ZGM 782 20 halaman.
Important safety requirements
This hob must be installed in accordance with the Gas
FITTING THE GAS HOB
WITHOUT A COOKER HOOD ABOVE
Safety (Installation and Use) Regulations (Current
Edition) and the IEE Wiring Regulations (Current
Edition). Detailed recommendations are contained in the
following British Standards Codes Of Practice: B.S.
6172/ B.S. 5440, Part 2 and B.S. 6891 Current Editions.
The hob should not be installed in a bed sitting room
700 mm
with a volume of less than 20 m
3
. If it is installed in a
3
room of volume less than 5 m
an air vent of effective
400 mm
area of 110 cm
2
is required. If it is installed in a room of
volume between 5 m
3
and 10 m
3
an air vent of effective
400 mm
area of 50 cm
2
is required, while if the volume exceeds
11 m
3
no air vent is required. However, if the room has a
door which opens directly to the outside no air vent is
3
3
required even if the volume is between 5 m
and 11 m
.
If there are other fuel burning appliances in the same
room, B.S. 5440 Part 2 Current Edition, should be
consulted to determine the requisite air vent
FO 2369*
requirements.
FITTING THE GAS HOB
WITH A COOKER HOOD ABOVE
Location
The hob may be located in a kitchen, a kitchen/diner or
bed sitting room, but not in a bathroom or shower room.
Before making the cut out in the worktop ensure that
the edges of the hob that are to be near either a side or
700 mm
rear wall have a minimum distance of 55 mm. between
the edge of the hob and the wall.
400 mm
The minimum distance combustible material can be
fitted above the hob is 400 mm. If it is fitted below 400
400 mm
mm. a space of 50 mm. must be allowed from the edges
of the hob. The minimum distance combustible material
can be fitted directly above the hob is 700 mm. A
minimum distance of 100 mm. must be left between the
side edges of the hob and any adjacent cabinets or walls.
FO 2231*
8