Zanussi ZGO68410BA Panduan Pengguna - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZGO68410BA. Zanussi ZGO68410BA 21 halaman.
Halaman Cetak4. For the burner to operate correctly, make sure
that the arms of the pan supports are inserted
in the recesses of the enamelled plates.
REMOVING AND ASSEMBLING PAN
SUPPORTS
After cleaning of the hob, make sure that pan
supports are in a correct position. In order to place
a pan support properly, make sure that its arms fits
the cut-outs placed at the base of the burner as
shown in the picture. This way, a pan support is
stable and fixed.
CLEANING THE HOB
•
Remove immediately: melted plastic, plastic
foil, sugar and food with sugar, otherwise, the
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
There is no spark when you try
to activate the spark generator.
The flame extinguishes immedi-
ately after ignition.
The flame ring is uneven.
dirt can cause damage to the hob. Take care to
avoid burns.
•
Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny
metallic discoloration. Clean the hob with a
moist cloth and a non-abrasive detergent. After
cleaning, wipe the hob dry with a soft cloth.
•
To clean the enamelled parts, caps and crowns,
wash them with warm soapy water and dry them
carefully before you put them back on.
CLEANING THE SPARK PLUG
This feature is obtained through a ceramic ignition
candle with a metal electrode. Keep these
components well clean to prevent difficult lighting
and check that the burner crown holes are not
obstructed.
PERIODIC MAINTENANCE
Speak to your local Authorised Service Centre
periodically to check the conditions of the gas
supply pipe and the pressure adjuster, if fitted.
Possible cause
The hob is not connected to an
electrical supply or it is con-
nected incorrectly.
The fuse is blown.
Burner cap and crown are
placed incorrectly.
Thermocouple is not heated up
sufficiently.
Burner crown is blocked with
food residues.
Remedy
Check if the hob is correctly
connected to the electrical
supply.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Place the burner cap and
crown correctly.
After lightning the flame, keep
the knob pushed for equal or
less than 10 seconds.
Make sure that the injector is
not blocked and the burner
crown is clean.
13