Zanussi ZIFN633K Panduan Pengguna - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZIFN633K. Zanussi ZIFN633K 20 halaman.
Halaman Cetak
Problem
You can hear a constant beep
noise.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds when
the hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
Automatic Heat Up does not op‐
erate.
The heat setting changes be‐
tween two levels.
The control panel becomes hot to
the touch.
comes on.
comes on.
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
16
ENGLISH
Possible cause
There is water or fat stains on the
control panel.
The electrical connection is incor‐
rect.
You put something on one or more
sensor fields.
You put something on the sensor
field
.
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor is damaged.
You use a very tall pot which blocks
the signal.
The zone is hot.
The highest heat setting is set.
Power management operates.
The cookware is too large or you put
it too close to the control panel.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the zone.
The cookware does not cover the
zone markings.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
Remedy
Clean the control panel.
Disconnect the hob from the electrical
supply. Ask a qualified electrician to
check the installation.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long to
be hot, speak to an Authorised Service
Centre.
Use a smaller pot, change the cooking
zone or operate the hood manually.
Let the zone become sufficiently cool.
The highest heat setting has the same
power as the function.
Refer to "Daily use".
Put large cookware on the rear zones,
if possible.
Refer to "Daily use".
Put cookware on the zone.
Make sure the cookware covers the
zone markings fully.
Use cookware suitable for induction
hobs. Refer to "Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
comes