Zanussi ZKT 850 D Buku Instruksi - Halaman 8

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Kompor Zanussi ZKT 850 D. Zanussi ZKT 850 D 19 halaman. Glass ceramic induction hob

Halaman Cetak

Operation of the Cooking Surface

When the cooking zones are switched on,

they may hum briefly. This is a characteristic

of all induction hobs and does not impair

either the function or service life of the appli-

ance.

Operating the hob

The hob is controlled via sensor keys. They react to

gentle touching of the glass with a finger. If you press

the keys for approximately one second, the control

commands are carried out. Each action is confirmed

with a signal tone.

Press the On/Off button.

The control system is activated. "

four displays and the decimal point flashes. All cook-

ing zones are now ready for operation.

The next command must be entered within 10 sec-

onds. If this does not happen, the appliance

switches itself off automatically.

Operating the cooking zones

After you have put the hob into operation with the

On/Off button, you can now activate the cooking

zones within 10 seconds. When this period has

elapsed, the hob is automatically switched off.

1.Press the key corresponding to the required cook-

ing zone. "

." is shown in the appropriate display

and the decimal point indicates that the cooking

zone is ready for operation.

2.Select the required heating power from (1-9) with

the keys + or -.

From

. you can directly switch to

key.

If, after selecting the heating power, you have not

placed a pan onto the cooking zone,

point out that there is no pan present.

If you then place the pan on the cooking zone,

appears and the heating power is displayed: The

cooking zone is now in operation.

The keys + or - have a repeat function. If you

keep them pressed, the required power is

continuously increased or reduced.

You cannot simultaneously press several

cooking zone keys.

." is shown in the

by pressing the

is flashing to

dis-

g Surface

Controlling the cooking power

The table below is merely intended as an example.

The power stages which are recommended for cook-

ing in this table depend on the type of pan and also

on the type and volume of the food which is being

prepared.

Power stage

1 - 2

3 - 4

Switching off a cooking zone

The cooking zone is switched on and the decimal

point which marks the selected cooking zone is dis-

played.

Press the key - in order to turn down the power to 0.

The cooking zone automatically switches itself off

after ten seconds.

How to switch off a cooking zone: Press the

keys + and - simultaneously: "

matically displayed.

." is shown in the corresponding display as long as

the temperature of the cooking zone does not

exceed 60°C.

is shown in the display if the residual heat is above

60°C (see "Residual heat display").

Switching off the appliance

The appliance can be switched off at any time with

the Stop/Start button. All cooking zones are

switched off and the displays show a warning of

possible residual heat which is still present.

Safety switch-off

If a pot or a pan, a damp cloth or spilled food covers

several sensor keys for approximately ten seconds,

the safety system automatically switches off the

appliance.

Press the On/Off button to switch back on, see the

section "Putting the cooking field into operation".

Cooking level

Melting, heating

Simmering

Steaming, Braising

Boiling, steaming

Gentle Frying

Fry well

Cooking water and oil,

deep-fat frying

." is auto-