Zanussi ZKT 862 LX Panduan Petunjuk Pengoperasian - Halaman 23
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kompor Zanussi ZKT 862 LX. Zanussi ZKT 862 LX 25 halaman. Ceramic built-in hob
Halaman Cetak
Installation dimensions
The opening in the cabinet must correspond to the
standard dimensions. The necessary information can
be found in the dimensional sketch.
The separation between the lower surface of the
·
hob and the parts of the furniture below it must be
at least 20 mm.
The lateral separation between the sides of the
·
hob and the cabinet must be at least 50 mm, and
must be at least 50 mm from the rear panel.
This appliance conforms to Type Y (IEC 335- -2- -6)
with regard to fire protection. Only appliances of
this type may be installed on one side of adjacent
cabinets or walls.
Installation
1. Cut out the worktop according to the prescribed di-
mensions (Fig.1). (Saw exactly along the scribed
line.)
2. Fix according to Fig. 2
Position A must be used for screwing--on the catch
springs (Fig.1).
Important: The screw must be driven into the worktop
as illustrated.
Avoid overtightening. Do not use electric or pneumatic
screwdrivers unless they have, adjustable slipping
clutches (set to 1--1.1 Nm).
3. Check the sealing for proper fit and full contact.
4. Place the ceramic hob in the cut--out.
Removing the glass- -
ceramic hob
1. Disconnect the appliance from the electrical sup-
ply.
2. Push the hob upwands from underreath.
166
min. 50 mm
min. 50 mm min. 50 mm
20 mm
Fig.1
R5
Fig.2
1 Catch spring
2 Screws
3 Worktop
20 mm
4 Frame
5 Sealing tape
6 Glass ceramic plate