Zanussi ZKT 863 LX Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Kompor Zanussi ZKT 863 LX. Zanussi ZKT 863 LX 32 halaman. Ceramic hob
Juga untuk Zanussi ZKT 863 LX: Panduan Petunjuk Pemasangan dan Pengoperasian (36 halaman)
Halaman Cetak
Safety cut-out
The cooking zone(s) for which you want to use the
safety cut-out function must be switched on.
1. Using the timer sensor panel
zone for which the safety cut-out is to be set.
By touching the timer sensor panel
active cooking zone is selected in a clockwise direc-
tion, and the corresponding control lamp will flash
rapidly. Hereby the (e.g.) left rear control lamp corre-
sponds to the left rear cooking zone. 00 will appear
in the timer display.
The next active cooking zone is selected by touching
the timer sensor panel again
2. While the control lamp is flashing rapidly, use the +
or - timersetting sensor panels to set the desired
period of time for this cooking zone up until the
point where it automatically switches itself off (e.g.
15 minutes).
The safety cut-out function will be activated after
several minutes
The control lamp will now flash more slowly and the
remaining cooking time will be shown in the display
as it elapses. If the safety cut-out function has been
set for more than one cooking zone, the time dis-
played will be that for the cooking zone with the
shortest period of cooking time remaining. The con-
trol lamps for the other cooking zones for which the
safety cut-out function has been set will illuminate.
To display the remaining cooking time for any of
these cooking zones, it must be selected using the
timer sensor panel
, and the corresponding control
lamp will then flash rapidly.
To reset the remaining cooking time the desired
cooking zone must be selected using the timer sen-
sor panel
. The corresponding control lamp will
then flash more rapidly. The settings are reset using
the + or - timer setting sensor panels.
After the set period of cooking time has elapsed the
cooking zone automatically switches itself off, an
acoustic signal sounds for two minutes and the timer
display flashes 00.
3. To switch off the signal, touch the timer sensor
panel
.
3
To make the setting more quickly, touch any of
the + or - timer setting sensor panels until
the desired value is reached.
If the - timer setting sensor panel is actuated
first, the time setting will begin at 99 minutes,
and if the + timer setting sensor panel is actu-
ated first, the time setting will begin at
1 minute.
, select the cooking
once the first
.
15