Zanussi ZKT 863 LX Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Kompor Zanussi ZKT 863 LX. Zanussi ZKT 863 LX 32 halaman. Ceramic hob
Juga untuk Zanussi ZKT 863 LX: Panduan Petunjuk Pemasangan dan Pengoperasian (36 halaman)
Halaman Cetak
1
Safety Instructions for
the Installer
• A device must be provided in the electrical installa-
tion which allows the appliance to be disconnected
from the mains at all poles with a contact opening
width of at least 3 mm
Suitable isolation devices include line protecting
cut-outs, fuses (screw type fuses are to be re-
moved from the holder), earth leakage trips and
contactors.
• In respect of fire protection, this appliance corre-
sponds to type Y (EN 60 335-2-6). Only this type of
appliance may be installed with a high cupboard or
wall on one side.
• Drawers may not be fitted underneath the hob.
• The installation must guarantee shock protection.
• The kitchen unit in which the appliance is fitted
must
satisfy
the
DIN 68930.
• For protection against moisture, all cut surfaces
are to be sealed with a suitable sealant.
• On tiled work surfaces, the joints in the area where
the hob sits must be completely filled with grout.
• On natural, artificial stone, or ceramic tops, the
snap action springs must be bonded in place with
a suitable artificial resin or mixed adhesive.
• Ensure that the seal is correctly seated against the
work surface without any gaps. Additional silicon
sealant must not be applied; this would make re-
moval more difficult when servicing.
• Avoid installing the appliance next to doors and
under windows. Otherwise hot cookware may be
knocked off the rings when doors and windows are
opened.
• The hob must be pressed out from below when re-
moved.
stability
requirements
Electrical Connection
Before connecting, check that the nominal voltage of
the appliance, that is the voltage stated on the rating
plate, corresponds to the available supply voltage.
The rating plate is located on the lower casing of the
hob.
The heating element voltage is AC230V~. The appli-
ance also works perfectly on older networks with
AC220V~.
The hob is to be connected to the mains using a de-
vice that allows the appliance to be disconnected
from the mains at all poles with a contact opening
width of at least 3 mm, eg. automatic line protecting
cut-out,earth leakage tripsorfuse.
A type H05VV-F cable or one with a higher grade
must be used as the mains connecting cable.
The connection must be carried out as shown in the
diagram. The connecting links should be fitted ac-
cording to the appropriate connection diagram. The
earth lead is connected to terminal E. The earth lead
of
must be longer than leads carrying electric current.
The cable connections must be made in accord-
ance with regulations and the terminal screws
tightened securely.
Finally, the connecting cable is to be secured with
the mains cable cleat and the covering closed by
pressing firmly (lock into place).
Before switching on for the first time, any protective
foil or stickers must be removed from the ceramic
glass surface.
1
Once connected to the mains supply check
that all cooking zones are ready for use by
briefly switching each on in turn at the maxi-
mum setting.
25