Zanussi ZBB28441SV Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku Zanussi ZBB28441SV. Zanussi ZBB28441SV 17 halaman.
Juga untuk Zanussi ZBB28441SV: Panduan Pengguna (17 halaman)

Halaman Cetak
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The lamp does not work.
The compressor operates con-
tinually.
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Water flows inside the refriger-
ator.
10
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrect-
ly.
Many food products were
put in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Appliance is fully loaded and
it is set to the lowest temper-
ature
Temperature set in the appli-
ance is too low and the am-
bient temperature is too
high.
Temperature is set incorrect-
ly.
During the automatic de-
frosting process, frost melts
on the rear plate.
Food products prevent the
water to flow into the water
collector.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Set a higher temperature. Refer
to "Operation".
Set a higher temperature. Refer
to "Operation"
Refer to "Operation" .
This is correct.
Make sure that food products do
not touch the rear plate.