Zanussi ZBF 6114 Buklet Instruksi - Halaman 4

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Pembeku Zanussi ZBF 6114. Zanussi ZBF 6114 20 halaman. Zanussi washer dryer brochure
Juga untuk Zanussi ZBF 6114: Spesifikasi (5 halaman), Spesifikasi (7 halaman)

Zanussi ZBF 6114 Buklet Instruksi

Operation

Before use

Remove all securing tapes. Wash inside the
appliance with lukewarm water and bicarbonate of
soda (5 ml to 0.5 litre of water). Do not use soap or
detergent as the smell may linger. Dry thoroughly.

Freezer controls

1
Pilot light (green)
2
Thermostat control knob
3
Fast-freezing indicator light (yellow)

Starting your appliance

Insert the plug into the wall socket.
The appliance can be activated by turning the
thermostat knob (2) beyond the «O» position. When
the pilot light (1) is illuminated and a sound is on only
for 2 sec. this shows that the appliance is on.
Push the button ( 4) , the sound signal alarm will get
off and pushing the button a second time the super
control light (3) light up. The freezer will start to
operate.
The freezer is switched off by turning knob (2) to
position «O» and a sound is on only for 2 sec.

Temperature control

The temperature inside the freezer is regulated by a
thermostat with different temperature positions and
one «OFF» (O) position.
Position «1» = minimum cold
Position «6» = maximum cold
Turn the thermostat dial to the required position.
An intermediate position is usually the most suitable,
although the temperature will be affected by:
• Room temperature
• How often the door is opened
• How much food is stored
• Position of the appliance
In determining the correct temperature control setting
4
➀ ➀
➁ ➁
➂ ➂ ➃ ➃ ➄ ➄
4
Push button for fast-freezing and for stopping the
audible signal (warning light on)
5
Warning light (red)
all these factors have to be considered and some
experimentation may be necessary.
To obtain a lower temperature, turn the thermostat
control to the highers numbers; to obtain a higher
temperature turn the control to the lower numbers.
When altering the temperature setting, allow 24
hours for the temperature to stablise before making
further changes.

Quick freezing

For quick-freezing, push the button (4) . The super
control light (3) will then light up.
If the quick-freezing function is not ended manually,
the appliance switch off the quick-freezing function
after 52 hours. The yellow light goes out.
The quick-freezing function can be ended manually
at any time by pressing the button (4) again. The
yellow light goes out.