Zanussi ZBF11420SA Panduan Pengguna - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku Zanussi ZBF11420SA. Zanussi ZBF11420SA 12 halaman. Zanussi freezer
Juga untuk Zanussi ZBF11420SA: Panduan Pengguna (40 halaman), Panduan Pengguna (24 halaman)
Halaman Cetak
Control panel
Pilot light
1
Temperature regulator
2
Quick Freeze light
3
Quick Freeze switch
4
Alarm light
5
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The pilot light will light up.
Important! If the temperature inside the appliance is too
high the Alarm light will blink. Active the Quick Freeze
function.
Switching off
To turn off the appliance, turn the Temperature regulator
to the "O" position.
The pilot light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings to
obtain the minimum coldness.
• turn the Temperature regulator toward higher settings
to obtain the maximum coldness.
First use
Cleaning the interior
Before using the appliance for the first time, wash the inte-
rior and all internal accessories with lukewarm water and
some neutral soap so as to remove the typical smell of a
brand-new product, then dry thoroughly.
4
1
2
3
4
However, the exact setting should be chosen keeping in
mind that the temperature inside the appliance depends
on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Quick Freeze function
Press the Quick Freeze switch to activate the Quick Freeze
function.
The Quick Freeze light will light up.
This function stops automatically after 52 hours.
Press the Quick Freeze switch to deactivate the function at
any time.
The Quick Freeze light will switch off.
Excessive temperature alarm
An increase in the temperature in a compartment (for ex-
ample due to an power failure) is indicated by flashing of
the Alarm light.
When normal conditions are restored the Alarm light will
switch off automatically.
Important! Do not use detergents or abrasive powders, as
these will damage the finish.
5
A medium setting is generally the most suitable.
www.zanussi.com