Zanussi ZF 134 UN Buklet Instruksi - Halaman 6

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Pembeku Zanussi ZF 134 UN. Zanussi ZF 134 UN 13 halaman. Freezer zf 134 un

Take the hinge removed from the upper part of the

appliance on the opposite side (see Fig. 4), and, using

the screws removed from the lower part, ﬁx it to the

base of the appliance itself.

Remove and reﬁt the other hinge on the upper part of

the appliance on the opposite side.

Fix the two front screws into the upper and lower

hinges (Fig. 4).

Finally, check the alignment of the door and make

sure it closes properly.

After having reversed the opening direction of the

door, discard the original plastic insert removed and

ﬁt the insert supplied with the appliance on the

opposite side.

Fitting a decorative door panel

Important: The components needed to ﬁt the

decorative panel have been pre-ﬁtted on the

appliance.

The brackets are secured to the panel by means of

the 7 Ø 3.5x13 screws supplied.

Before starting to ﬁt the panel, remove the large

top bracket by unscrewing the screws and

adjusting pins pre-ﬁtted on the appliance door.

The small bottom bracket need not be removed.

Place the appliance in the position where it is to be

built in (Fig. 5).

The appliance is ﬁtted with adjustable feet; screw the

front and rear feet in or out to adjust the height of the

appliance to that of the recess.

Keeping the appliance central in the recess, slide it in

until its back touches the wall.

With a tape measure (or similar instrument), measure

distance (A) between the top edge of the door and the

top edge of the decorative panel, placing it next to the

recess.

D510

D467

Fig. 4

Fig. 5