Zanussi ZFX51400WA Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku Zanussi ZFX51400WA. Zanussi ZFX51400WA 12 halaman.
Juga untuk Zanussi ZFX51400WA: Panduan Pengguna (48 halaman)

Halaman Cetak

1. Remove the plug

from the power sock-

et.

2. Remove the top

hinge cover.

3. Unscrew the 2 re-

taining screws, and

remove the hinge from

the appliance.

4. Take the door off.

Do a final check to make sure that:

• All screws are tightened.

• The door opens and closes correctly.

If the ambient temperature is cold (i.e. in Win-

ter), the gasket may not fit perfectly to the cabi-

net. In that case, wait for the natural fitting of

the gasket.

In case you do not want to carry out the above

mentioned operations, contact the nearest Af-

ter Sales Service Force. The After Sales Serv-

ice specialist will carry out the reversibility of

the doors at your cost.

Electrical Connection

Caution! Any electrical work required to

install this appliance should be carried out

by a qualified electrician or competent person.

Warning! This appliance must be

earthed.

5. Remove the screw

fixing the lower door

hinge and the other

screw fixing the lower

door hinge and the

foot. Then remove the

door hinge and the

foot as shown in the

Figure.

6. Loosen the screw

fixing the foot oppo-

site the lower door

hinge in order to re-

move the foot.

7. Fix the door hinge

and the correspond-

ing foot on the oppo-

site side and then the

other loosened foot at

the former place of

the door hinge as

shown in the Figure.

8. Please make

sure to place the

lower foot below

the door hinge. The

lower foot is recog-

nizable by its 4 ribs

on the outer sur-

face.

9. Fix the door onto

the lower hinge pin.

10. To fit top door

hinge, remove the

plastic blanking plugs

carefully, and refit

them in the holes left

by the hinge retaining

screws.

The manufacturer declines any liability should

these safety measures not be observed.

11. Refit the top hinge

using the 2 retaining

screws, taking care

that the edge of the

door is parallel with

side of the cabinet.

12. Replace the hinge

cover.

13. Relocate the han-

dle and the plastic

plugs to the opposite

side.

14. Level the appli-

ance, wait for at least

four hours and then

connect it to the pow-

er socket.