Zanussi ZNB 404W Buku Instruksi - Halaman 11

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Pembeku Zanussi ZNB 404W. Zanussi ZNB 404W 20 halaman.

Halaman Cetak

Before any maintenance or cleaning is carried

out you must DISCONNECT the appliance from

the electricity supply.

Internal Cleaning

Clean the inside and accessories with warm water and

bicarbonate of soda (5 ml to 0.5 litre of water).

Rinse and dry thoroughly.

NEVER use detergents, abrasive powders,

highly perfumed cleaning products or wax

polishes to clean the interior as these will damage

the surface and leave a strong odour.

External Cleaning

Wash the outer cabinet with warm soapy water.

Once or twice a year dust the condenser (black grille)

and the compressor at the back of the appliance with a

brush or vacuum cleaner, as an accumulation of dust will

affect the performance of the appliance and cause

excessive electricity consumption.

When the Appliance is not in Use

When the appliance is not in use for long periods, discon-

nect from the electricity supply, empty all foods and clean

the appliance, leaving the door open to prevent unpleas-

ant smells.

HOLIDAY mode

The HOLIDAY mode is suitable when the refrigerator

compartment is empty but there is foodstuff stored in the

freezer.

The HOLIDAY mode is activated by pressing the "D"

fridge temperature setting button several times. The dis-

play ("B") shows the letter "H".

To exit from the HOLIDAY mode press the "C" fridge tem-

perature setting button.

Important: If the fridge compartment is off, the door

must be closed in order that the freezer is working prop-

erly.

In this condition, the electronic control of the appliance

functions automatically and periodically circulate the air

to prevent unpleasant smells and humidity.

Maint

enance & Cleaning

Maint

enance & Cleaning

Defrosting

Defrosting is automatic in this model.

To Change the Light Bulb

Should the light fail to work you can change it as below:

Break the circuit of the appliance.

Press the rear hook (1) of the lampcover by a screwdriver

and at the same time pull and rotate the cover in the direc-

tion indicated by the arrow (2). So the bulb can be

replaced. (Bulb type: T25 Daylight 230-240 V, 25 W, E

14 thread)

After changing the bulb replace the cover, snap it in place

and apply voltage to the appliance.