Zanussi ZV 180 R Buklet Instruksi - Halaman 6

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Pembeku Zanussi ZV 180 R. Zanussi ZV 180 R 7 halaman.
Juga untuk Zanussi ZV 180 R: Buklet Instruksi (11 halaman)

Halaman Cetak

CUSTOMER SERVICE AND SPARE PARTS

•

Before calling your local dealer for servicing

assistance, check the following points to see if

you may not resolve the problem yourself:

•

Make sure that the freezer is plugged into the wall

socket correctly, and that electrical current arrives

to the freezer without interruption.

•

Control the thermostat setting.

•

In the event that the freezer makes excessive

noise or vibration, make sure that it is not in direct

contact with the wall or adjacent furniture.

•

If defective operation continues after these

controls, call your local Service Network and

provide all the data listed on the rating plate:

model, serial number, etc.

INSTALLATION

Location

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc.

Ensure that air can circulate freely around the back

of the cabinet. To ensure best performance, if the

appliance is positioned below an overhanging wall

unit, the minimum distance between the top of the

cabinet and the wall unit must be at least 100 mm

(A). Ideally, however, the appliance should not be

positioned below overhanging wall units (B).

Accurate levelling is ensured by one or more

adjustable feet at the base of the cabinet.

Important

It is essential that the appliance be connected to an

efficient earth tap. For this purpose the supply cable

plug incorporates a special earth contact. If the

sockets of your domestic wiring system are not

earthed, have the appliance connected to a separate

earth wire by a qualified electrician in accordance

with existing safety regulations.

The Manufacturer declines all responsibility if

the above safety precautions are not observed.

This appliance complies with EEC directive

number 87/308 of 2/6/87 relative to radio

interference suppression.

This appliance complies with the following

E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and

subsequent mod)fications;

NP00

ATTENTION!

It must be possible to disconnect the appliance from

the mains power supply; the plug must therefore be

easily accessible after installation.

- 89/336 EEC of 3.5.89 (Electromagnetic

Compatibility Directive) and subsequent

modifications.

Electrical connection

Before plugging in, ensure that the voltage and

frequency shown on the serial number plate

correspond to your domestic power supply. Voltage

can vary by ±6% of the rated voltage.

To freeze fresh foods turn the fast freezing knob at

least 24 hours before introducing the food into the

freezer in order to ensure better freezing results.

Place the food to be frozen in the compartment as

shown in figure.

In order to freeze the quantity indicated on the rating

plate, arrange the food directly in contact with the

cooling surfaces. If the food is frozen in the baskets,

the maximum quantity freezable is slightly less.

Important

When electrical current happens to be cut off, the

freezer door must not be opened. If the power failure

is short (up to 6-8 hours) and the freezer is full, there

is no risk that the food will spoil. If the power failure

lasts longer, the food must be consumed as rapidly

as possible, or otherwise cooked and re-frozen

again.

Frozen food storage

When the freezer is being turned on for the first time,

or after a prolonged period of disuse, turn the N/S

knob to the Quick-freezing position and then wait at

least two hours before introducing the food to be

conserved. You may then return the knob to the «N»

position. This two-hour waiting period may be

avoided if the freezer has already been in operation.

To obtain the best performance from this appliance,

you should:

if large quantities of food are to be stored, remove all

drawers and baskets from appliance (except for the

last one at the bottom) and place food on cooling

shelves.

Pay careful attention not to exceed load limit stated

on the side of the upper section (where applicable).

Thawing out frozen foods

Frozen foods must be allowed to thaw out before use

either in the refrigerator (meat, poultry, fish, etc.) or

at room temperature (ali other foods) according to

the available time. Frozen products which come in

small-sized or separate packages may be cooked

directly without thawing; obviously, in this case, the

cooking time will fast a little longer.

Ice-cube production

Fill the trays with water to 3/4 of their height, to

permit the expansion of the ice, then put them in the

space below the quick-freezing compartment (see

the diagram). If the water in your area is rich in

minerai salts (limestone, in particular), we advise you

to use noncarbonated mineral water for the

production of ice cubes. The ice-cubes may be

shaken out of the plastic trays with a slight twist.

10 kg

PR176/1

Cold accumulator

A cold accumulator is supplied in the freezer; this

increases the leght of time for which food will keep in

the event of the power failure or breakdown. It must

be placed in the top drawer.