Zanussi 7332543286072 Panduan Pengguna - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi 7332543286072. Zanussi 7332543286072 24 halaman.
Juga untuk Zanussi 7332543286072: Panduan Pengguna (24 halaman), Panduan Pengguna (20 halaman), Panduan Pengguna (20 halaman), Panduan Pengguna (24 halaman)

Halaman Cetak
Zanussi 7332543286072 Panduan Pengguna
Removing and installing the oven glass
panels
You can remove the internal glass panels to
clean it. The number of glass panels is different
for different models.
WARNING!
Keep the oven door slightly open
during the cleaning process. When
you open it fully it may accidentally
close causing potential damage.
WARNING!
Do not use the appliance without the
glass panels.
1. Open the door until it is at an angle of
approximately 30°. The door stands alone
when slightly open.
30°
2. Hold the door trim (B) at the top edge of
the door on both sides and push inwards to
release the clip seal.
2
B
3. Pull the door trim to the front to remove it.
16
1
WARNING!
When you take out the glass
panels the oven door tries to
close.
4. Hold the top edge of the door glass panels
and pull them up one by one.
5. Clean the glass panel with water and soap.
Dry the glass panel carefully.
When the cleaning is complete, install the glass
panels and the oven door. Do the above steps
in the opposite sequence. Install the smaller
panel first, then the larger.
CAUTION!
The screen with a printing on the
inner glass panel must face the inner
side of the door.
CAUTION!
Make sure that after installation the
surface of the frame of the glass
panel on the screen with a printing is
not rough when you touch it.
CAUTION!
Make sure that you install the
internal glass panel in the
appropriate seats.
Replacing the lamp
Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
2. Clean the glass cover.
3. Replace the lamp with a halogen, 230 V, 40
W, 300 °C heat resistant lamp.
4. Install the glass cover.
www.zanussi.com