Zanussi GAS COOKER ZCG 641 Buklet Instruksi - Halaman 19

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kompor Zanussi GAS COOKER ZCG 641. Zanussi GAS COOKER ZCG 641 20 halaman. Zanussi cooktop user manual

Halaman Cetak

Replacement of gas oven

burner nozzle

To replace the gas oven nozzle, follow this procedure:

1. Remove the bottom plate of the oven cavity ("A");

2. Undo the two fixing screws ("C") which keep the

oven gas burner in place

3. Gently slide the oven gas burner off the injector

support ("D") and slowly move it to the left hand

side, taking care not to cause stress to the spark

plug connection wire ("E") and the thermocouple

("F") conductor;

3. With a socket spanner 7 unscrew and remove the

gas burner injector ("D"), and replace it with the

required one (see "Technical Data");

4. Reassemble the burner following the same proce-

dure in reverse.

5. Replace the Gas Type Sticker (it is located near the

gas connection ramp) with the one relevant to the

new gas type which is supplied with the injector kit.

Minimum level adjustment

of gas oven burner

After setting the oven on maximum temperature with

door closed for about 10 minutes, turn the knob to

minimum.

To reach the thermostat by-pass screw and adjust the

minimum level, act as follows:

– take out the gas oven control knob;

– in case of conversion from natural gas to LPG, tightly

screw the by-pass screw of thermostat (see diagram,

letter "G");

– to convert from LPG to natural gas, unscrew the

by-pass screw, until a regular small flame is reached.

– finally check that turning quickly the tap from

maximum position to minimum position, the flame

does not go out;

– reassemble the knobs.